DIY Button Bracelet

DIY Button Bracelet

If you have a collection of buttons that are just waiting for a great project, this DIY Button Bracelet is for you.  Made with a variety of buttons, this colorful bracelet is great for any outfit.  If you have some extra buttons on hand, you could even make a necklace or a pair of earrings to complete your set.

DIY Button Bracelet


  • 1 Button for your closure
  • Variety of buttons with 4 holes
  • Copper chain
  • 2 Strands of hemp cord approximately 30” in length
  • 32 Seed beads



  1. Take your hemp cord and add a dap of glue to the ends and roll to form a somewhat point, let dry. This will make it easier to thread the cord through the holes without it fraying.
  2. Take your copper chain apart where you have approximately 11 or 12 one inch pieces.
  3. Thread the two pieces of cord in through your closure button, fold in half to center it, and then tie a knot up close to the button. You will be working with four strands of cord.
  4. Now take three buttons and start threading them onto the cord. Be sure to thread the same piece of cord through the same hole in each button for each section. (By section, I mean each set of three buttons) This will keep the buttons fitting snuggly together.

    diy button bracelet

    diy button bracelet
  5. Make sure that each strand of hemp cord goes through the same placement hole of the button. Bottom right of each button, top right of each button, top left of each button, and the bottom left of each button.

    diy button bracelet
  6. Now thread your one inch piece of chain onto all four strands of cord. Pull everything up snug together.

    diy button bracelet

    diy button bracelet
  7. Separate your cord and thread your buttons onto the cord again following step #4.

    diy button bracelet
  8. Continue with steps #4 and #5 until you get the bracelet to the desired length.

    diy button bracelet
  9. Tie a knot at the end, then straighten the end strands of cord and tie another knot leaving an opening just large enough for your closure button to fit through.

    diy button bracelet
  10. Thread 8 seed beads onto each left over strand of cord, tie knot, and clip left over ends off.

Your Recently Viewed Projects

Leave a Comment


Cancel Reply to Comment

Thanks for your comment. Don't forget to share!


Report Inappropriate Comment

Are you sure you would like to report this comment? It will be flagged for our moderators to take action.

Thank you for taking the time to improve the content on our site.

Join our community of 5 million crafters!

Thank You for Signing Up!
There was an issue signing you up. Please check your email address, and try again.

More from "Bracelets"



Close Window