Giant Button Wall Art
Sewists, crafters, kids, and adults will LOVE this Giant Button Wall Art from Mitzi Curi! Made with a large wooden circle, this simple DIY decor project is perfect for adding a splash of color to a small corner or your children's bedroom. This would also be an adorable addition to your future craft room. You could even use a variety of circles to create a whole wall of adorable colored buttons!
- Round wood tray
- White spray primer (if you want to paint your button a light color)
- Spray paint in the color of your choice
- A drill with a large spade bit, about 1/2 to 3/4 inch in diameter (sometimes called a paddle bit)
- Cotton filler cord (from the upholstery supply area of a fabric store)
- A "D-strap" metal hanger
- E-6000 glue
I decided to prime the tray first with a couple light coats of white primer so I could see the marks for the drill holes and for better paint coverage.
Now I could measure the center and decide where to place marks for the four holes with a pencil. At first, I used a measuring method, then I said "heck with this" and I positioned four pennies where I wanted the holes and traced around them.
Using a drill with a spade bit, drill four holes. Tip: start drilling from the front of the tray. The inevitable splinters will show up more on the back. Of course, if you prefer two holes rather than four, that's fine too.
Sand the drilled holes so they are somewhat smooth. I rolled up a piece of sandpaper to get right inside. Surprisingly, the tray I used had cardboard sandwiched between the two layers of wood. Yours might not. Remove all the dust with a damp paper towel or tack cloth.
Now spray paint your button the color of your choice. I had to use about three coats of "Perfect Pink", waiting between each coat to dry according to manufacturer's directions.
Take your cording and thread it through the holes until you are satisfied with the appearance. I decided to leave a "thread" hanging out the front, and I tucked the other end in the back.
The package of D-strap hooks includes little nails, but I decided to use E-6000 glue instead because the tray was so thin I didn't think pounding a nail into it was a good idea.
FYI: I actually glued the hook closer to the top edge than what is shown in this picture. Wait 24 hours for the glue to cure before hanging.
- After the glue dries for 24 hours, your button is ready to hang!