Red and Black Dangly Plastic Earrings

Red and Black Dangly Plastic Earrings

Red and Black Dangly Plastic Earrings
This image courtesy of primecp.com

For these Red and Black Dangly Plastic Earrings, you need a sheet of red plastic canvas and a sheet of black plastic canvas. From the red canvas, cut one large piece, taper the ends, then make one small piece also tapered at the end. Repeat the same two pieces with the black. Now using a piece of earring wire, put one earring hook than one large red, small black, large black than finally small red tie it off.

Project TypeMake a Project

Time to CompleteUnder an hour

Bead Technique UsedStitched

Difficulty LevelBeginner

Materials List

  • Red plastic canvas
  • Black plastic canvas
  • Jewlry wire
  • Earring hooks

Instructions

  1. Cut out a 7x4 piece from both the red and black canvas

  2. Cut out a piece of 5x4 from both the red and black

  3. Taper the ends of all of the pieces

  4. Using the jewlry wire add one earring hook on the wire

  5. Add one large red

  6. Add one large black

  7. Add one small red

  8. Add small black

Your Recently Viewed Projects

Leave a Comment

Rate

Cancel Reply to Comment

Thanks for your comment. Don't forget to share!

Close

Report Inappropriate Comment

Are you sure you would like to report this comment? It will be flagged for our moderators to take action.

Thank you for taking the time to improve the content on our site.

Join our community of 5 million crafters!

Thank You for Signing Up!
There was an issue signing you up. Please check your email address, and try again.

More from "Earrings"

 

 

Close Window
Close Window
Get Our FREE Newsletter and Occasional Special Offers

Privacy Policy